we are looking for info on newly acquired deadwood special #1795. it has had the oil cooler added, crankshaft plug pulled to allow stator cooling, had the...
http://www.superxowners.com/tech/newowner.htm Welcome aboard, check out this site on new owners and a list of everything that needs to be done to it. ride...
trn signals (hazards) came on for no reason this happened several times, shut off by themselves. After trning bike off and restarting problem seemed to...
Marty... You have a short and it is grounding out through your turn signal switch. This needs to be fixxed ASAP!! Go to the resource board and post these...
checked battery conection and wiring around but found no short. opened trn sgnal housing and looks fine. trned bike on and started to move wires around to...
Nope... it never works that way... it's waiting for you to be as far away from home as possible. (from experience). ... __________________________________ ...
short ride still have problem. they go on whenever they want, sometimes it works out, expecially when it can read my mind and know when Im about to make a...
I ran a test on the battery voltage, the reading was taken across the battery terminals, AGM battery less than 1 year old and OEM stator less than 500 miles on...
... sometimes ... Switch Is Contact & No Contact, Nothing Else. It's Possible The "Switch Contacts" Themselves Are Not Aligned Properly Or Warped. It May Even...
#417 here, looking to pull out the transmission cassette soon.. I understand that there is a special tool required. Is this something that can be purchased...
I am not the right person to answer, but I believe the earlier models require no special tools whereas the later models do. I think there is something on the...
... Call Jamie & Marty at EH Atlantic. Great people that will work with you for everything you need for your "X". 540-298-9310 Good luck and Ride Safe, Van...
Thanks. I found the link at the SuperX site; http://superxowners.com/tech/TrannyRemoval.pdf It shows two tools required for the job.. Both have part numbers ...
Hi, You have an early S/N scooter, I have #443. You do not need any special tool to remove the transmission/ clutch. Do your self a favor, for future...
I'm going, but I'll be riding the Valk - I'm not into trailering and I need my bags. We need to set up a time and place to hook up. Also - Maggie Valley -...
I have been using this same aftermarket stator for 3,000 miles now and still going. The VAC is low on the aftermarket stator about 15 lower than stock. I don't...
Wires looked fine. I did send the stator back to SuperX Parts so maybe it will help in designing one with Electro Sport. The voltage never seamed right...
Backseat and I want to say Merry Xmas to all the X'ers. We will be riding in to Tucson sun riders toy parade again this year. The 2 oil coolers with one with...
