Thinking outside the box1 Innovation; I LOVE it! -bj ... From: julian To: EHimprovements@yahoogroups.com Sent: Tuesday, June 01, 2004 7:39 AM Subject:...
Have the bike tore down & ready to put it back together Just me luck when I decide to put it back together after the trans rebuild that all the available...
Richard, I cannot remember which Board it is on, but Cappy made his own ccompensator tool and told how. Search the archives or contact Jim Kepford (Snowy91)....
Sending you the tool.(In the Mail) Good to talk with you Richard Dale Richard, ... ccompensator tool and ... Also, I lived near Spokane ... when I last...
Dale you are a life saver thanks & see you in 2 weeks....... EasyX will be back on the road. Thanks Everone who has helped. Richard P. Kranzler Rebar...
Anyone tried to make a crash bar that would also function as an oil cooler? anotherehmasochist <jegssr@...> wrote:Installed my crash bar today. Adds...
i was wrenching on 853 this weekend and found this when i went to wipe down the primary case. if youi are changing out the o rings on the slave clynder please...
Thanks Mark; that's disappointing because the primary has about the best chrome on the bike! ... From: Mark Gleason To: EHimprovements@yahoogroups.com Sent:...
Good news; the crash bar is worth a solid 10 degree temp reduction. Bad news; it took hours of work to get the inside of the bar clean enough to not...
Jim, did you just run it straight through one side of the crash bar, or the whole crash bar? How much did it increase your oil capacity? How much do you...
How'd you clean the inside? ... From: Jim To: EHimprovements@yahoogroups.com Sent: Tuesday, June 22, 2004 8:48 PM Subject: [EHimprovements] Re: crash bar Good...
Sorry for the late reply. The inside of the crash bar is contaminated with "flaking slag" caused by the welding process. I used a parking brake cable and ...
Jim, ... Yahoo has changed the way it searches the archives for Yahoo Groups. Now you have to keep clicking on the "next" link as it only searches as handful...
John, We picked up my wife's new 2004 1200C Sportster this spring, and I was impressed with the new tire it comes with. It's not HUGE, but is noticably fatter...
Help! I think my front motor mounts are going, getting vibration at different speeds. What is the best way to check them, and what mounts are the best...
Hi, Suport the engine with a jack and a block of wood then remove the mounts, you can see if they are deterioated. I think Atlantic EH can sell you OEM, or...
To top off the list of reasons why I should sell my X, I now live on a dirt road!!! Every thirty minute ride requires a two hour cleanup! I'll get another...
Bro John, I live on a sand (sugar sand) road. It is about 3/4 of a mile to my house. I will not sell either of my X's. In fact I have just purcased my 3rd. I...
Just bought by X (#855)a few weeks ago. It hasn't had any of the necessary upgrades yet. I'm going to get some of them done within the next few days at John's...
Cooler is always safer for these machines. You're safer due to your location (I live in the South), but snarled in traffic on a hot summer day is not good...
Cooler is always safer for these machines. You're safer due to your location (I live in the South), but snarled in traffic on a hot summer day is not good...
Hi, Check out #443 in the photo section. The dual oil cooler seams to be working for me here in the South West. A fan assist is a must. Suprx443 ... ...
