Morning folks, I have a 1947 ?? 4 banger engine I bought at auction a couple years ago and am in the process of installing it in a half sized Farmall F-20 ...
GOOD PLAN--ALSO PULL PLUGS AND LUBE THE CYLINDERS(red mistery oil) pre lube cam and anything you can see --top and bottom crank engine (without starting)...
Good Morning to you, I am sure you will get a lot of advice on what to do. I got a 47 Crosley that had been sitting in the woods in the Oakland Hills for 20...
Howdy from SD: Ron Drop the Pan and clean the oil pump. Check the compression their should not be more than 10# deffrentrencs between any cylinders regards ED ...
Ron, You should pull the water jackets off and clean any sediment and rust that has collected. It will save you some overheating problems in the future. If...
Jim's advice is good. Marvel Mystery oil will work wonders on stuck rings. Isn't it wonderful having an engine which has side plates allowing you to clean...
Thanks Guys. I'm definately going to pull the oil pump and clean it, then pull the water jacket covers. Red Marvel also will go into the cylinders a while...
PUT THE PULLER ON-PUT A SMALL SLEDGE ON ONE SIDE AND HIT THE OTHER SIDE,SHOULD WORK NOTE -MAKE SURE THE NUT IS ON BUT NOT TIGHT-- DAMAGED FINGERS ARE YOUR...
Ron, The procedure should be governed by extreme caution; bearings are not so easy to find. As suggested, clean the pump. If there are any plugs or lines (like...
... turned the engine over, it's apparent there are no valves stuck closed.)" Just a note: they can be stuck open too..I have in the past pumped oil into an...
LETS SEE--Barry is about 30 miles from you-60 round trip-truck gets 6 mpg--thats about $22.50--Better dig out the Crosley or take the wifes car if she will...
Good ideas. I probably will use the grease gun idea. Thanks Ron ... turned the engine over, it's apparent there are no valves stuck closed.)" Just a note:...
Thanks Bob, This all makes sence to me. Ron Robert Connearney <rconnearney@...> wrote: Ron, The procedure should be governed by extreme caution; bearings...
I used two five pound hammers and a Pitman arm puller on my one ton Dodge truck. Never got it off. Used a hot wrench and got it off. Replaced the seal (a...
Well, I've seen David work, (or rather watch his wife work)so i know why he needs band aids (sorry David) and I'm not going to comment on Seb at all!! Barry,...
Reminder from the Calendar of Crosley_Gang http://groups.yahoo.com/group/Crosley_Gang/cal Thursday Night Chat Reminder Thursday March 2, 2006 10:00 pm - 11:00...
Crosley_Gang@yahoogro...
Mar 3, 2006 2:25 am
8564
radio for sale chrome nose one 175.00 plus shipping needs rebuilt before it goes on e-bay...
I an selling reproductions of these rare and obsolete blueprints ,all copies are framable and easly readable. They come with instructions and large color...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
