Thank you all, but I do see one down side to this. My Crosley money will now be forcefully ripped from my fingers by my wife to buy baby things. I guess I will...
Barry My child bride & I are hoping for our first grandchild also so I get it. Good luck & best wishes for the new year. Don Gritti ... This message was sent...
This past week I went up to NC and picked up our Crosley. This is our first Crosley ever. First time i ever even got near one. Wow! is it small! Title states...
You sure hit the nail on the head with the careful statement. That's why I love that country song, "Blink" ain't it the truth!!!! Chakapeah ... From:...
Steve; Congratulations, glad to hear you got yhe car home. You will find that our vendors Yankee Crosley , Service Motors , and Dave Edwards will have all...
Hi Steve, Congrats on the new addition. I have a set of Crosley rims with new radial 4.80 X 12 tires on them. Rims are painted white. Let me know if you are...
I got a note the other day from Trevan Baker out on the West Coast about a group of people out there that are thinking about driving in for Wauseon this year...
Better double up on those "Hard Luck" trophies. In a message dated 1/2/2009 2:57:20 P.M. Eastern Standard Time, tmkldwwj@... writes: I got a note the...
Freed up the left front brake drum(it was stuck) Checked the tranny fluid, it was bone dry. Pulled the shifter. The gears all look like new with no wear or...
I read in my quarterly about a member making overload springs to help keep your Crosley from leaning to the left. Well I added one more leaf to the left front...
Most models of Crosleys are setup with an extra leaf on the drivers side. Many Crosley have springs that need re-arching and are sagging. Properly arched and...
What size clutch does our 1950 Crosley have in it? Is it 6 1/2"? I have not pulled it yet. The clutch pedal was stuck dead to the floor. The body was against...
You might pull off the flywheel cover (if it still has 0ne) and maybe get a measurement that way. Since it is a 50' you might have a 6 ½, but the only sure...
Assuming the engine is the original. 6 1/2" Clutch switch over CD-205500 VC-20783 This was in a September 25th 1950 Service Letter Actual visual inspection...
When you look at the fingers of the pressure plate if it has adjustable buttons, then it is a 6.5 inch. If it has plain finger, then it is a 6" Barry ... forth...
The bottom inspection plate is still on it but there was another opening i could look up inside. The fingers are plain with no bolts. So it looks like i have a...
I need some help with my Farm-O-Road. I have acquired a 1952 Farm-O- Road and can not get it to run. It has no spark. I have replaced, the coil, points, cap,...
Check the wire that goes from the coil to the dist.Ihad the same prob.It may look ok but it very little time to change out. Bob ... From: rickknox19...
Rick, I am guess Bob is meaning the coil wire. I have seen the wire going though the dist. housing short out causing miss fires and would be sure could ground...
I would look very carefully at the point where the wire enters the distributer base there is a post there that has a stepped insulating washer that tends to...
Jacked up the back end today and checked the diff grease. The rear was full, it looked clean and smelled good. While i was under there i removed the gas tank....
I know, I know, we're all too fat. I'm going lobster and melted butter diet...........pete ... From: Jim Bollman To: Crosley_Gang@yahoogroups.com Sent:...
Thanks Guys, I don't remember a insulated washer at the stud. What would the insulator on the inside look like? I restore antique tractor trailers and can make...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
