I am in need of a pair of bucket seat tracks for my 68 montego project. I understand that the montego used the same tracks as were on the 66 comet and torino....
So I'm guessing this is due to the Comet & Falcon being born as "economy" cars. Ford decided to combine the two molded Bakelite parts into one to reduce...
I have a similar opinion to Mr GEM becuase I drive my car regularly. But besides comfort, I was rear ended by some chump on a cell phone a few years ago. If...
Thanks for the advice, I'm gonna get more into it and decide when I pull the heater core out and start putting new parts in. If I don't think it's close to...
Thanks John, I picked up the 9" differential today at the junk yard and the owner tells me the same thing about the drive shaft. I guess I will need to talk...
How difficult is it to change a speedo gear with the C4 trans still in the car? Is it just unscrew the cable and change the gear, or does the tail have to...
Regarding the tail housing for a toploader...go to _www.davidkeetoploaders...he_ (http://www.davidkeetoploaders...he) is an expert on toploaders and carrys...
If its the gear on the cable you just remove the cable end and change . Is it the trany rear seal ? If so just remove driveshaft and remove seal and replace...
Hello, a fellow contacted me to say he has a perfect hood for sale to fit a 65 Comet. Its white and dont need painting!!!!?His name is Conrad? Lavender out of...
petescomet@...
Mar 2, 2008 5:48 pm
38581
I watched a new episode of my classic car today and seen a VERY quick Blip in the very beginning of a white 64 comet wagon doing a burn out. Any body know...
Going to all this trouble... how about a 5 speed? really help with gas mileage on the freeway. Tremec 3550 according to moderndriveline has the same bolt...
The Ford Aerostar has an aluminum driveshaft that's the right spline for the C4 output shaft and about the right length for your car. I use one in my 66 ...
It might have been the 64 wagon featured in the March issue of Car Craft magazine. It says the man, Dan Spere, paid $125 for a gas cap for it. He built it 'in...
Arne, here is the part number that I sent the other fellow... it is a snap shot right out of the catalog.. Each set does 1 seat. Requires 2 sets per vehicle. ...
Thanks Rod: The number I came up with was a C6OZ6361704 A/B and C6OZ6361705 A/B which would make it a torino/ comet part...Arne Rod Ditz <rodditz@...>...
James, Sorry, I have been terribly busy and probably won't get to measuring the seat heights until the weekend.. is that OK, or are you needing these...
Couldn't make it out clearly, but it looked like a Maverick with a Mustang spoiler and a GT type hood scoop. But then it could be my imagination too....
Cometeers This link was in the Comet East Mailbox. Looks like a nice summer ride. http://www.thegreenvilleguide.com/comet%201965.htm Comets Rock !!! Don...
I recently watched the movie "The fastest Indian" with Anthony Hopkins,on the Bonneville salt flats one of the other racers used a Mercury station wagon as a...
Just wondering if you guys can pass along a little advise. I have a 63 2 door Comet with a straight 6 and 2 speed automatic transmission. I bought this car...
Since the first Cobras and Sunbeam Tigers came with 260s, it has been proven that they can be built to make a ton of power. That said, if cost is a ...
That will be fine. I also ordered a set of seat tracks from Autocrafters. Thanks again James Rod Ditz <rodditz@...> wrote: James, Sorry, I have been...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
