Jerry, As mentioned, if it is the air compressor that is cycling, there is an air leak somewhere. Least likely problem is a leaking air bladder. Most likely...
I am not very mechanical but I think it is the air compressor pumb that goes on and off. If you have suggestions. please let me know since I am taking it in...
OK, once we have that established, it is easier! Number one - let's look at the air system. When you open the lower compartment where the HWH hydraulic system...
When I purchased my Chinook it was represented to me as a 2000. When I registered it in Arkansas, the registration came back as a 1999. I was told, by the...
I'd suggest the source in Yakima just talked about on this forum that has some inventory of parts. I had gotten one from the factory just before it closed. ...
I beleive that your rig is fine. Trail Wagons purchased the Ford cutaway chassis in lots and then built the motorhomes on them. Typically for any given year...
It would be a great resource on this site if we had a photo album and/or a file dedicated to showing pictures and PDF brochures for all the years and models of...
I may be the only challenged one here but I need to share this. Went over to have propane tank topped off and guy said it wouldn't take any more than a few...
George - I have had more experience than I ever wanted with the Propane tank. It, and the gauge, are products of Manchester Tanks - located in Canada I think....
Dave Doesn't your sending unit clip on over the plastic visual gauge on the tank?? Mine looks like it does but I can't move it so thought it might be glued on...
The plastic gauge/sender unit is all one piece, on mine at least. It has plastic clips around the edge that clip to the metal cap that the float is attached...
More information - I found this while looking for inside panel manufacturer: Information from Manchester Tank: "There is another gauge on the tank – you will...
This is GOOD info..but I'm not sure I can envision getting a magnet close enough with the plastic cap on top of the gauge. BUT, I wonder if the unit isn't also...
Magnet works fine...we did it at the propane dealer - not that hard, you are adjusting the position of the gauge needle, not anything to do with the float...
George and Dave, when we purchased our 2000 Concourse, the former owner passed on a float valve which he said would have to be replaced when the tank was...
Here is the Rochester Twin Sites sending unit.because mine has an "R" on it this may be what we have. The panel circuit board is a JRV Products MDL 10010A but...
George! you found the clue to it I needed... (I am a champion Googler) http://www.jrvproductsinc.com/ There is still the picture of the Chinook panel - they...
What perfect timing (or a very good coincidence); just spotted the following post tonight on the Class B Forum: "... try the RV Heritage museum library. ...
NOW!!! I've got.thanks Dave.so simple...kind of like when we were kids and we'd put a magnet on each side of a window pane and run these little plastic men...
This stuff Dave just mentioned may be the key to the whole thing....I suspect that a good jolt could maybe cause the magnetic needle to move out of synch. The...
I can now speak with a modicum of authority on this subject having just converted the existing 13" Audiovox in my '99 Chinook Concourse to a 15.6" Widescreen...
... oh, Laws, what have I done now? I went to plug in the 12 volt connector to my new lcd tv, but it is a hair bigger that the hole. The connector is 19 years...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
