Can-AmMotorcycles : Message: Re: Another oil pump question

Can-AmMotorcycles · Can-Am Motorcycles

Message search is now enhanced, find messages faster. Take it for a spin.

Having problems with message search? Fill out this form to ensure your group is one of the first to be migrated to the new message search system.

Another oil pump question

Message #3558 of 3889 |

Re: Another oil pump question

Don't forget to open the bleed screw. This allows the oil to flow down the line an into the pump.

Jeff

Mon Jun 29, 2009 10:05 pm

"Jeffrey Langille" <jeffrey.langille@...>

Offline

Message #3558 of 3889 |

Expand Messages	Author	Sort by Date
How do you know if your oil pump is operating properly? I'm a bit scared to add straight gas and find out that it wasn't! The bike is a '77 qualifier 175....	tengsr	Jun 24, 2009 1:16 am
Put pre-mix in the tank and make sure your oil reservoir is full. After you have run it for a while, pull the side cover off and see if there is oil in the...	rjtyson	Jun 24, 2009 1:26 am
I'll wont say never, but these pumps rarely fail, I mean almost never. The only ones I have seen fail had either dirt in the pump or bits of the foam Can-Am...	Brian Kirby bnkirby...	Jun 24, 2009 1:49 am
How fast a drip? Should I see something in 10 seconds. I pulled off the lower of the two lines that goes into the crankcase on a TNT ... From: Brian Kirby...	LARRy koch larryakoch	Jun 28, 2009 5:06 pm
I pulled the lines into the engine off of mine yesterdy, and they drained, then I hooked them back up and started the bike. You can see them being filled back...	tengsr	Jun 29, 2009 2:26 am
You should see oil imediately, I don't post on here very often but have had several can-ams over the years. i suffered from the foam dissenigrating that was in...	steve pruden lawnboy58	Jun 28, 2009 7:40 pm
Don't forget to open the bleed screw. This allows the oil to flow down the line an into the pump. Jeff...	Jeffrey Langille langilj	Jun 29, 2009 10:05 pm