The inside dimensions are as follows...
83 CR250 24.4mm
86 CR250 16.1mm
88 CR250 29.4mm

I could be slightly off due to normal wear & tear. Ought to be close enough.

Stan
WV


Frank Zee wrote:
>
> Call me out an inside to inside measurement/dimension on the 2 tabs
> that hold the pegs on the frame. I might have something here (1 set
> with springs) that will work.
>
> Before I built my CR500AF when I was running the standard 1991 steel
> frame, I ordered up a set of 1996 CR250 pegs since they were
> a wide/modern design that cleaned out well. They fit the CR500 frame
> perfectly and I tried one from my 96 CR250 that I had at the time to
> check the fit and Lo and Behold....They were perfect!
>
> Let me know the dimension and I'll sell this set with springs to
> whoever wants them and if it is a fit, all you need to do is order a
> set of 1996 stock honda pegs...I'll go out to the shop and dig them
> out and measure the width of the peg cleats as well as the inner
> dimension but I'll bet they're a match.
>
> Frank Z MX BONZ www.mxbonz.com <http://www.mxbonz.com>
>
> --- On *Sat, 1/10/09, Stan Talago /<whymee415@...>/* wrote:
>
> From: Stan Talago <whymee415@...>
> Subject: Re: [CR250] Wider pegs on an 86 CR250
> To: CR250@yahoogroups.com
> Date: Saturday, January 10, 2009, 4:26 PM
>
> Scott. I too will be looking for modern pegs to fit the '86.
>
> I have here a 83, 86 & a 88. I will let you know what I find out
> when I
> do the pegs. If you find out something, please hit me up with the
> info.
>
> Regards
>
> Stan
> WV
>
> Scott Stanford wrote:
> >
> > Anyone out there know the hot set-up for modern pegs on a 1986
> CR 250 ?
> > Scott
> >
> >
> >
>
>
>