Jim, I suppose that you could pour (if it would pour!) some JB weld in to the ends of the swing arm. You would then have to drill a pocket into this new...
I need some advise, my bike will not post any trouble codes when I put in a loopback and the fuel pump will not cycle in pre start operations. The check...
I need some advise, my bike will not post any trouble codes when I put in a loopback and the fuel pump will not cycle in pre start operations. The check...
it could be, sure. does the bike run at all? if it does, does it run well or poorly? if it doesn't, does it show signs of having any electrical at all? if the...
This may be the obvious, but have you checked your battery. When the power falls below 12 volts your ECM may start acting strange. I would start with that. ...
Probably something pretty simple. First check the battery. If it is above 11 volts, then start looking for a short or broken switch in the run circuit --...
I'm not positive but the X-1 rim should hold a 190 without any trouble. The rims normally will accommodate one size larger than stock and won't likely rub on...
The Marchesini wheels will hold a 180 and the PM wheels will hold a 190, but you have to be careful about how close the tire gets to the belt. How close it...
Thanks for the input. I think I'm going with the 180 Dunlop 208. New compound makes it stickier and the deeper tread means the same mileage as the previous...
Great choice. I've been using the 208gp for the last 4-5 sets of tires now and absolutely love them. They offer fantastic traction and are very predictable...
Has anyone seen any good write ups or any other aftermarket stuff to relocate the license plate and get rid of the fender type thing that it hangs on? Thanks ...
do you mean where the wiring connector comes out on the bike, or which wires are connected to it? the accessory fuse feeds the orange-and-white line, so any...
hey Sam this is one taht american sportbike sells. It lokks pretty good but its pricy, there is a guy on ebay that sells them for a lot cheaper less the...
posting for a friend: 2001 X1, ~5000 miles; power commander and aftermarket pipe (don't know what kind); yellow & nuclear blue. he's asking ~$6500. if you're...
Hi, I had the local HD/Buell shop install the Race ECM and so far I'm not too happy with it. It really bogs bad at WFO around 3000-4000RPM. I thought this...
I personally am looking to get another stock pipe. So let me know if you dump it. As for quite and performance. They do not go together. Free breathing ...
Cowen, John J
John_Cowen@...
Jul 15, 2003 4:26 pm
476
I have a stock pipe, 300 miles on it... excellent condition... make offer. ... From: Cowen, John J To: 'Buell_Tech@yahoogroups.com' Sent: Tuesday, July 15,...
Does anyone how to get hold of a scanalyzer and how much it cost? Does anybody make an after market version or PC version? Apparently you can program the ...
I would need it for a 2001 X1. If that makes a difference. Does yours fit that description? ... From: Eric Fenton [mailto:ejfenton@...] Sent:...
Cowen, John J
John_Cowen@...
Jul 15, 2003 5:23 pm
479
This is off my 2001 X1. stock exhaust ... From: Cowen, John J To: 'Buell_Tech@yahoogroups.com' Sent: Tuesday, July 15, 2003 1:23 PM Subject: [Buell_Tech] X1...
let me add a data point for your interest: I have 99 S3, race ECM, K&N filter, stock exhaust. I noticed an increase after both (first ECM, then later the...
I'm not familiear with your set up (I have a 97 s3) but on your ECM , if it was designed for an after market race pipe and you have stock it would flow too...
Hopefully my ECM will learn, I have only about 100 miles on it right now, and the butt dyno says its making more power somewhere. THere is still a dog spot...
try some WD-40 on the idle adjustment screw. It should go lower than you'll need to go. ... Yes, this is true, to my understanding. A lot of my knowledge of...
Side note, I put the S3 handle bars on my X1 last week and the bike is 100% more comfortable. Yet I can still ride just as agressively as I did before. I am...
Check with Sargent http://www.sargentcycle.com/default2.html . They don't list Buell specifically on their website, but they can make anything. Of course Buell...
