<http://geo.yahoo.com/serv?s=97359714/grpId=4150683/grpspId=1705308511/m sgId=1926/stime=1182785586/nc1=4430620/nc2=4025321/nc3=4670553> Just a bit back, there...
Hi all, I read on some web site that if you vent the breather outside the airbox/intake you gain 4 to 6 HP? Any truth to this? Also, I read about opening the...
Hi all, I have a mid-range lean spot at about 2500 to 3500 rpm. THe bike will sort of stumble or miss when the throttle is partly open, such as a slight coast...
Would anyone happen to have a parts manual for a 2000 M2 Cyclone in .pdf? I have the service manual but would like to find a parts manual for ordering parts....
I don't have a parts manual, but if you go to Chicago HD website (http://chicagoharley.com) and enter -00y it will bring up all parts with that suffix. I do it...
Hi Diver, I am in the same boat. Let me know if you score a parts manual. I am SOO tired of getting the WRONG part from my dealership. I have been lurking on...
Will do, and if you need any pages from the service manual (99-00 M2), just let me know. I can scan what you need and send. Everything you need is in there, ...
[Moderator's note: not strictly about Buells, but interesting] 0-60 in ONE SECOND - World's Fastest Electric Motorcycle Straddling the Killacycle, a 619-pound...
Name is joe, I own a x1 tube frame buell. I am looking for a set of telescopic pushrod tubes that work worth a darn, the z_ppers model doesn't work worth a...
My '05 JUST did something very similar, but it tore off right above where it welds to the muffler. What the hell's that about? Anyway, any suggestions for...
I put on a Jardine right around the first of the year. In combination with a very low tech mixture adjustment, I noticed an improvement in performance and a...
This is a Buell/H-D question: I have been doing some reading on H-D engines (easier to find material on H-D than Buell specific) and, although I know I have a...
That's what I thought, but I seem to remember the guy at H-D, when I went to get some parts, saying something about a twin cam, and that's what confused me. ...
I have serial number one for California Buell M2. It is original orange frame with Volcano Grey body work. It's mostly stock and runs great. It has only 8000...
hi.. new buell owner here from indiana.. i got a 99 cyclone pretty cheap and i was wondering about possible problems...this is a strong running bike and i...
... Hello and welcome to the wonderful world of Buells. I recently picked up a 2000 M2 Cyclone and, although my front rotor doesn't rattle at idle, the only...
N, There used to be a kit to replace the "buttons" on the older rotors, but they would eventually start to rattle again. The later rotors don't rattle. It...
All: I have a problem with my 2000 X1 Lightning that I hope sounds familiar to someone out there that has been down this road before. First, the bike is...
Only on altitude changes like going up a mountain. This has been described to me as an inability for the system to change fast enough to compensate for the...
Hi Everyone, been lurking around the group for a while now and thought I would say Hello. I ride a 97 Thunderbolt S3T, purchased back in April of this year. A...
... When I bought my 97 S3 new in 97 it was actually un-rideable because the carb was so lean. The dealer put a jet kit in it for free and it got much better,...
I know that this may sound a bit simple, but, can anyone recommend a good outdoor waterproof cover for a Buell M2? I have seen them range from $25 to over a...
Rod, I wanted to invite you to check out my site. www.buellforums.com We cater to Buells and Hogs. Its only a couple months old and we could use some help. We...
