... Remove the turn signals, remove the fairing and then maybe remove the headlight, I forget. I know the turn signals and the fairing have to come off. When...
Well, I finally got my 02 X1 back on the road after about two months down. So far everthing is checking out OK with the ride in today. I do have a question...
well, harley had to get them from *somewhere*. actually, I wonder how far back those exhaust studs go. there doesn't seem to be much incentive to change the...
Usually there is a hole in the head/rocker box that does not go anywhere, so it isn't a problem if the gasket covers it up. I would not cover up any known oil...
Actually thinking about it, the oil comes up to the head through the push rods, so this is a phoney hole. Doooh ! :0 Should have realized this earlier. ...
All: I've just about taken all the beatings I can stand from the rear shock of the 2000 X1. It has supposedly been thru the recall, but it seems like the...
Anyone out there have a Vance and Hines SS2R exhaust for a 98 S3? The front mount ripped off the pipe and left a big hole. I had it welded up but that only...
I know some of you really like the way the stock airbox on the tubers look, but I hate it.. I used to have a ForceWinder intake with a K&N on it and a V&H...
... There is no reason that changing the intake and air filter should decrease the gas mileage unless the jets you're changing to are way to rich. I went...
There is no reason that changing the intake and air filter should decrease the gas mileage unless the jets you're changing to are way to rich. The idea was...
Tim, Skip over to the American Thunderbike forum http://www.americanthunderbike.org/ and pose this question to Dawg. He might have some insight for you... ...
... It may be necessary to re-jet, but that should not effect your gas mileage. Well, not unless you pick up a bunch of power and use it. You don't re-jet to...
Dang it, it happened again, the same flippin' exhuast stud has snapped on the rear cyclinder. Why is this happening? I don't torque it down tight at all....
I am looking at a 2000 X1 Millenium and it has 17000 miles on it, it was laid down but all parts on that side have been replaced, they are asking $4800 for...
My guess is that the nut is not sitting perfectly flush on the flange. This would cause one side of the stud to have more stress than the other causing it to...
ssei21012 <ssei21012@...> wrote:I am looking at a 2000 X1 Millenium and it has 17000 miles on it, it was laid down but all parts on that side have been...
... I actually did have a split washer on it. I just went out side and was looking at it again. I ran the engine up and noticed the whole exhaust system...
Broke my White Bros. e-series front mount twice until I used the following: Bolt head -- large fender washer -- large rubber washer -- exhaust bracket -- large...
i think i'm going to be looking at getting a Buell sometime in the next year... maybe next few months.... i am leaning towards an X1 (not new, maybe 3 or 4...
Okay, can someone solve this mystery for me. My 1999 X1 will not start. Yesterday it ran like a BAD ASS without a hint of any problems, not a sputter, burp,...
Let me know your experience. I just bought a '99 Cyclone on ebay for $3750. Hope this is getting near the bottom of the value. I plan on riding it a while...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
