Bob you are a smart feller!! ... From: bob savage To: 66_67_dodge_chargers@yahoogroups.com Sent: Tuesday, February 01, 2005 12:52 AM Subject: Re: -> Torsion...
Greg, Have you looked in the 66 Charger Supplement? It may be of some help. If you don't have a copy go to Newt's site and check out pages 25-28. Here's the...
When I bought the charger I have now I gave $5000.00 including shipping from California to Ky and that was in 1994. The place I bought it from told me it was...
Thanks for all the information.... My problem is not that the steering wheel is not in a visual center position, but that when the car is going straight, I can...
Greg, I wrapped the carpet around the panel (it's about an inch) and glued it. When the rear panel is upright, it presses against it and keeps it tight. I...
... arm bushings? I used those on my '69 R/T and got 3.5 degrees of positive caster and the darn thing goes straight at 130 mph with hands off of the wheel! ...
Ron, you are too kind. Please keep in mind that I have never done any high performance work, and spec's change for those type vehicles. Check with someone more...
This tread is getting interesting. I believe you might be right Ward. The reasons, the score from these two professions are so close (and in the higher...
Im by trade an electronics technician but work mostly now on television and our trade I think has always been treated like auto repairmen. Most people dont...
I have taken the advice that you guys have offered and ordered a set of adjustable rocker arms and a new set of push rods. I have run the valves a hundred...
When I had the old faithful Mopar '509 cam in the 440, I adjusted the rocker arm screw and spun the pushrod with my fingers at the same time. When I felt the...
You are correct Bob, that's how I remember it. You can also adjust the pressure balance by raising both wheels off the ground and start the engine. You don't...
I am also starting to rebuild my front end, does anyone know if the off set tie rod ends are the only ones that will work or can I use the stright ones if I ...
Help me save face, here! I know this was a service at alignment shops. I remember vividly having the steering wheel repositioned on my father's car while we...
Terry Hoover
tehoover@...
Feb 2, 2005 1:06 am
48852
It does a good job, but I'm really looking for the trim detail - like how the edges are finished, exactly where the carpet ends on some pieces, etc. Pictures...
I don't doubt it, but when it comes to 64-up Chryslers, there's only one way to fly. Dave Casey ... From: Terry Hoover To: 66_67_dodge_chargers@yahoogroups.com...
I would also be interested to know of any differences between straight and off-set tie rod ends. I have not done any high performance work, and was not aware...
Greg; I think I know where you mean.. on mine, the ends of the carpet just tuck in behind the trunk side panels. I don't have the panels in my trunk right now,...
That was exactly what I needed to know. It's what I remembered, but I knew I could go to this site and get the definative answer - or as definative as you can...
Steve, I know nothing about racing applications, and would not begin to say so. Hopefully with all the gear heads in here, I will be able to learn some cool...
CHARGER For-Sale, 1966, 54133-original miles, factory 4-speed. Original Engine Block, Has Six Pack. Full gauge set including In-Dash Tachometer. Full length...
... Steve dodgeman_69 In 66_67_dodge_chargers@yahoogroups.com, bob savage <rsav57@s...> ... begin to say so. Hopefully with all the gear heads in here, I will...
i replaced my battery cable ends with BRASS ones Was that a bad move or doesn't it matter? ... From: my66_69cars To: 66_67_dodge_chargers@yahoogroups.com Sent:...
regarding tie rod ends...i went to Autozone in NY and paid 25 bucks for one and 45 for the other because of the reverse thread....well...i didnt think that was...
Consider it a lesson learned! Check out the source guide for your elec. problems,plans on there somewhere to make a constant voltage regulator from radio shack...
I am interested in a 4 speed car but I don't think that charger had a 6-pack option in 66 or 67. , Of course I don't know everything. what is the VIN # that ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
