Did the swap in my 65 C30... had a shop do all the work... What I can recall: 1) I think there was a cross member right at the rear of the motor that came out....
I want to upgrade to a dual master cylinder with the plans to swap in a front cross member with disk brakes in the near future. I really don't want to have to...
Group, I want to update my truck with power steering. Does anyone know what modern power steering box will bolt up to my 62 C10? Any help will be appreciated. ...
hi, i have a 1963 chevy c-10 long bed fleet side truck. it is bone stock with a 230 straight 6. i plan to keep it original. i am having a proplem with my tail...
You can replace your master cylinder with one from a 67 or newer truck. I replaced the master in my 64 C20 with a brand new one from Car Quest for around 30...
This does not apply to 6066 Chevy trucks but it does apply to anyone signed up for this list. If you have any more questions email me off list at...
6066_Chevy_Truck@yaho...
Nov 2, 2006 3:53 am
6557
Nothing bolts up. I understand you can get an adapter kit at one of the classic truck sites. I used an early 70's truck box that mounted easily on my 61 C10....
I can relate on confusing them my other pickup is a '37 street rod and I can nearly see the smoke curl out of their computers when they try to figure something...
Was it working correctly at one time and broke? ... From: Tom Megow <t_megow@...> To: 6066_Chevy_Truck@yahoogroups.com Sent: Wednesday, November 1, 2006...
Rick, Went through the exact same problem with my 63. The electrical stuff is absolutely the most frustrating and time consuming part of the whole restoration!...
the turning signals did not work when i got the truck, i put in a new signal switch and flasher, and this is where i am. i see in my chevy duty catalog that...
i brightened it all up with a wire brush & drill, the right side is lighting the high side element in the tail light position Tom Megow <t_megow@...>...
thanks texas, i suspect you are right about multiple problems, i think i may have gotten a bad switch or a 64-66 by mistake. the rear sockets are not the same...
i put in a new switch that i puchased from grumpy's in phoenix az who specialize in older gm trucks. i am wondering if i got a 64-66 switch by mistake. i plan...
I had to sand the brackets and the body to bare metal (very small area) to get good enough grounding to get bright taillights. I also sprayed painted the...
Pull the rear lamps and check that the pigtail/insulator is not reversed. Then check with a tester to make sure the brake lights (or tail lights) are...
LED lights work very well. Electronic flasher a must. ... From: 6066_Chevy_Truck@yahoogroups.com [mailto:6066_Chevy_Truck@yahoogroups.com] On Behalf Of Tom...
The switch should make no difference. You have a ground problem. ... From: 6066_Chevy_Truck@yahoogroups.com [mailto:6066_Chevy_Truck@yahoogroups.com] On...
Tim, Ill be in Kalamazoo Tuesday evening can I get your phone # Tom Tim <boxerider@...> wrote: Group, I want to update my truck with power steering....
I have read online that I could do a pretty easy upgrade for my '63 by replacing it with one from a early 70's to mid 80's. I just found out that my neighbor...
if you have a 63 or later truck,you need a mc from a 71 up truck for disc brakes.67-70 are front drum.i put a power booster from a 73 c10 on very easily.it...
Hi Club Menbers My electrical problems are temporarily resolved. My thanks to everyone who commented. Pretty much everyone was correct. The new signal switch i...
hi chris, i have a 90 1/2 ton burb complete front assmbly in my 66 carryall,you will need to enlarge a couple of holes {or more ?} and use new grade 8 bolts...
Rick. Now that you have good grounds in those circuits, you can save yourself a whole lot of grief later If you go back to each connector and liberally coat ...
One small correction. Dielectric grease is neutral. Electricity and ground can pass through but not "intermingle". That's why it works in this application....
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
