I just picked up an 06 E350 Diesel Quigley, and have a couple of basic questions I hope someone can answer. I drove it 1200 miles home, and each fillup was...
I wouldn't be surprised if there were still 7 gallons when the light comes on.---- I've personally tried to put 285/75/16's on several Quigleys, and they...
HI Shaun, I can't comment on the clearance (yet) But I have a 01 Diesel Quigley and I fill up near empty (don't have a light) and my customary fill up is 24ish...
O H I O 1994 FORD E-350 4x4 29' Motorhome POSTED 06-1-09: This 1994 29 foot Gulfstream Ultra Motorhome is located in Huron, Ohio. The 4x4 conversion was...
Well, say for a person that is dealing with injuries that may or may not prove to be permanant. Where they have some difficulty getting in and out of the...
I'll take some pictures as I go along with this. It's hard to find info on these so let me know what you find. They come up on eBay for time to time, a...
With a twin beam (TTB) setup, A Ford conversion can get by with 1 in of lift. Not the best for towing or offroad, but OK otherwise. If you get creative and...
Send Craig @ Salem Kroger an email, I'm sure he'll have some input for you. Seth ... From: laurence357mong To: 4x4van@yahoogroups.com Sent: Tuesday, June 02,...
Cool, pics would be great. Well, I spoke with the guy who has the remaining Dana V/Vemco parts. He has quite a few of the big parts, but no sub-frames. Is...
OK Seth, will do. Curious, why are you recomending this contact???? Just to give me a better understanding. I am continueing to also pursue the Dana V/Vemco...
Hey Chris, I'm looking into installing some belly armor. How much did your old steel plate weigh, and how much does your current set-up weigh? And how strong...
I don't remember the exact weight, but I want to say it was in the 100lb range in steel. The aluminum saved a lot, enoughto make it easy fir me to move it...
Hey, Looking for a 460 oil pan that will clear the crossmember on my 83 E350? The deep portion of the pan needs to be at the rear of the pan. Sure appreciate...
I've always been under the impression from my research, that quigley's will take 33-34" tires max. post some pics and where u are if gonna sell your current...
I own and drive Chevrolet 78 1 ton Dana "V" Drive here in Portland, Oregon.It has never been stuck in snow, mud, or ice. It just keeps going. It is getting...
Check their website. They have to cut the tank to meet crash requirements. ... From: Shaun Feakes <s.sheep@...> Sent: Monday, June 01, 2009 4:10 PM To:...
About 5 years ago, I met up with Mike Quigley, Tiger, and the crew, while at Moab. Vanbo wasn't in action yet, but I wanted to see theirs, so I linked up with...
In answer to this original question. NO, the gear ratio for the rear differential must remain a match to the front wheel gearboxes. My understanding is they...
For better mileage (and who in a gas guzzling van couldn't use that), here's a couple ideas for discussion. I just recently stumbled upon these guys... ...
That's awesome Alan, I'm quite envious. I am hoping to eventually get my hands on a van with the system installed, or just come by the complete system and the...
Thanks. The chev's are differnent from the ford's they run 3.90 for the v-drive system. ... From: laurence357mong To: 4x4van@yahoogroups.com Sent: Thursday,...
Low cruising rpm and a good tune are the key's to the best mpg any vehicle can get. So I would consider overdrive the biggest single influence on mileage,...
OK, so to confirm, the ford's use a 3.90 gear ratio in the V drive systems???? Is that who you mean when you say "they"???? So, Chev's = 3.73 (assuming the guy...
Yes, the Ford = 3.90 The chev's I had no idea what they ran. Maybe the gear ratio's could be changed? I'm not sure. My guess is they used as many parts off the...
OK cool, thanks for the confirmation. When asked about ratio options,the guy that has the remaining parts claimed the gears were special made for this system,...