So I had a shift cable break right at the head. I well greased a replacement using high quality marine grease. Fed it into the outer with no problems. Screwed...
Put one of my sidecar rigs up on the bay. This is one sweet setup that won't disappoint. What's it gonna take to get you into this deal? Check it out here: ...
Perhaps the stiff issue is the reason that the previous cable broke. You can inspect your gear shifter machanism by looking at the batwing shaped part which is...
Nationally-syndicated talker Don Geronimo decides to buy a Vespa... http://saintssc.com/sounds/2007-10-12-Seg_5_Should_Don_buy_a_scooter.mp3 Enjoy, John M....
I recently swapped a old pinch bolt with a new one that had a peice of brass which is pressed against the cable by the bolt when tightened. I then noticed that...
John, I think that was the most painful tape I have ever listened to. Equally as disturbing is the fact that none of the callers to the program had a clue,...
Dont wait for us to advise, slacken them off and see. They will stretch so a little adhustment after a bit of use is necessary. Mick L ... From: "David D"...
Some pics from a great rally last weekend in St. Augustine, FL: http://www.flickr.com/photos/50634052@N00/sets/72157602956948910/ Feel free to leave comments. ...
Hey, i'm going to be down in NO for about 5 days, and was wondering if anyone had any connections/knowledge of any place in NO to beg borrow or rent a scooter...
2SS'rs, Some of my cables will not move at all, the cable seems to be rusted inside the outer sleeve, they are not kinked. I've had 2 of them soaking for a...
It they are that rusted, you definately need to replace both inner and outer cables. Don To: 2StrokeSmoke@...: roadcapden@...:...
Don Cameron
buddiedude@...
Nov 8, 2007 3:48 pm
29929
Well I have my hotel reservations at the super 8 (just a side note, special hotel rate are good for Thursday/Friday/Saturday only) I am working on the poker...
Hi all Im about to venture into renewing the gear and clutch cables (outers and inners ) on my old px125 and before i do I was looking for any tips and tricks...
Tape the new cables to the old ones when you pull them out for an easy time of it. Don To: 2StrokeSmoke@...: mikeyraynz@...: Sun, 11...
Don Cameron
buddiedude@...
Nov 11, 2007 8:48 pm
29932
where and when Steve Davis <sjdavis1@...> wrote: Well I have my hotel reservations at the super 8 (just a side note, special hotel rate are good for...
Your general theory is that you find some places that can use some business, that would be spots that your typical scooterist/tourist might want to visit:...
John- Thanks for another great option. On a typical day doing a poker run is the main or all day attraction. Eric wants this done in conjunction with Sundays...
The best way is to get a piece of inner wire moer than twice the length of the cable to be replaced. Thread it through the old & the new outers. Knot 1 end and...
I need to replace the cables in my Super. Does anyone know a source for teflon cable sets? Seems like these would last much longer than the standard ones. ...
I had always had good luck with Riva Vespa in Ft. Lauderdale. Takes forever, but great service at a fair price. I think he's merged with someone else, tho. A...
... ~~~I just went through this R&R on my 03' LML large frame some months back. I went to home depot to buy inner wire long enough to go through both the old...
... ~~~I forgot to mention...you might want to pull so you have close to the exact length of new cables on top as what was there for the oe cables. Why? I...
hey all, I'm here to visit my busy political girlfriend and wanted to hang with some scooterists. 617-407-9823. i'll be here till the 21st then in NYC till the...
